Synergy Tech Support

Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: turner2 on June 30, 2017, 09:53:08 AM

Title: servo tail control rod hitting mid range needle
Post by: turner2 on June 30, 2017, 09:53:08 AM

I just built an n5c install the ball on the servo horn in the proper hole binds on the mid range needle valve. I had to move the ball in one hold to correct this. Is this going to effect my tail hold?

Title: Re: servo tail control rod hitting mid range needle
Post by: Darren Lee on June 30, 2017, 10:08:48 AM

Did you install the pivot ball on the upper side of the bellcrank?

Title: Re: servo tail control rod hitting mid range needle
Post by: turner2 on June 30, 2017, 10:11:32 AM

Yes it is on the top. I was wondering if I could twist my carb enough to get clearance

Title: Re: servo tail control rod hitting mid range needle
Post by: Darren Lee on June 30, 2017, 11:04:46 AM

Yes rotating the carb slightly is fine. I've had to do that as well.

Title: Re: servo tail control rod hitting mid range needle
Post by: cml001 on June 30, 2017, 12:48:57 PM

May wanna double check that the tail servo horn is at 90 degrees and the ball is at the correct distance on the horn..

Title: Re: servo tail control rod hitting mid range needle
Post by: turner2 on June 30, 2017, 10:38:20 PM

Rotated carb tail control rod clears , maiden flight tomorrow , thanks guys

Title: Re: servo tail control rod hitting mid range needle
Post by: cml001 on July 01, 2017, 08:25:16 AM

Awesome! Glad u got squared away! Ur gonna love this bird... N5C kicks ass!