Synergy Tech Support

Synergy Electric Helicopters => Synergy 766 => Topic started by: exiged on August 06, 2017, 10:16:15 AM

Title: 766- a couple of questions :)
Post by: exiged on August 06, 2017, 10:16:15 AM

Hi,

Is a 38mm motor shaft (6mm diameter) long enough for this heli?

Does the kit come with cyclic servo horns?

thanks

Title: Re: 766- a couple of questions :)
Post by: curmudgeon on August 06, 2017, 10:56:54 AM

It should be.  I used a 40mm long motor shaft, and it stuck out past the pinion support bearing by quite a bit.

Title: Re: 766- a couple of questions :)
Post by: Wolf51 on August 06, 2017, 04:27:35 PM

Then kit includes carbon fibre servo arms and screws for cyclic that fit on a standard futaba "D" servo wheel. The futaba horns are not included. You can choose to use other servo horns.

Sent from my GT-I9507 using Tapatalk

Title: Re: 766- a couple of questions :)
Post by: cml001 on August 07, 2017, 06:37:16 AM

What they said..

Title: Re: 766- a couple of questions :)
Post by: exiged on August 07, 2017, 12:49:19 PM

Thanks chaps. I assume the plastic D horns are ok for 3d?

Title: Re: 766- a couple of questions :)
Post by: Wolf51 on August 07, 2017, 04:48:39 PM

Quote from: exiged on August 07, 2017, 12:49:19 PM

Thanks chaps. I assume the plastic D horns are ok for 3d?

Matt designed the servo arms for them.
I take that as a yes


Sent from my GT-I9507 using Tapatalk

Title: Re: 766- a couple of questions :)
Post by: Rodney Kirstine on August 07, 2017, 06:07:49 PM

Yes, the idea is that the splines in the plastic horn act as a sort of fuse and should strip before the servo gears do.