Synergy Tech Support

Synergy Electric Helicopters => Synergy 516 => Topic started by: turner2 on December 01, 2017, 06:20:55 PM

Title: cgy750
Post by: turner2 on December 01, 2017, 06:20:55 PM
Does anyone run off of throttle curves with futaba and tach blades on the ground . Does the talon 90 have to be programmed
Title: cgy750
Post by: Mark Dean on December 01, 2017, 08:34:44 PM
Yes throttle curves can be used in a variety of methods. The method is dependent on the type of throttle setup that is selected in the Talon. Yes the Talon must be programmed either by a computer linked via castle link software or via throttle stick programming. Keep in mind throttle stick programming is very limited. This discussion would be  most beneficial over the telephone or FaceTime. Please message me and let’s work out a time to discuss this as there are many ways you can set this up.


Sent from my iPhone using Tapatalk
Title: Re: cgy750
Post by: turner2 on December 04, 2017, 04:41:38 PM
Will do this is a winter project. I have not ordered anything yet but am about to.
Title: Re: cgy750
Post by: Mark Dean on December 04, 2017, 05:08:30 PM
Okay. Message me a phone number when you are ready and I’ll try to help you as much as I can with the setup.


Sent from my iPhone using Tapatalk