Synergy Tech Support

Synergy Electric Helicopters => Synergy 516 => Topic started by: Wayne Derrick on January 01, 2018, 04:56:04 PM

Title: Canopy Holes
Post by: Wayne Derrick on January 01, 2018, 04:56:04 PM

I am almost to the point of installing the canopy on the 516 build.  Do the holes need to be stepped up to a larger size before butting the grommets in or are they good as is?

Respectfully,

Wayne...

Title: Re: Canopy Holes
Post by: Josh Easter on January 01, 2018, 04:57:54 PM

Hi Wayne!!

Mine fit perfect!!!

Title: Re: Canopy Holes
Post by: TheBum on January 01, 2018, 05:04:56 PM

+1. They go in almost too easily, which is why the manual recommends using CA to hold them in.

Title: Re: Canopy Holes
Post by: dhoskins26 on January 01, 2018, 05:21:34 PM

Mine fit perfectly out of the box


Sent from my iPhone using Tapatalk

Title: Re: Canopy Holes
Post by: earlybird0513 on January 02, 2018, 05:51:45 AM

Mine fit with no adjuatment


Sent from my iPhone using Tapatalk

Title: Re: Canopy Holes
Post by: Cliff Chmiel on January 03, 2018, 08:13:25 AM

mine fit good I ran jet around the inside canopy hold them in place.

Title: Re: Canopy Holes
Post by: Wayne Derrick on January 03, 2018, 05:43:11 PM

Thank You Everyone!  I will press on and install the canopy as is.

Respectfully,

Wayne Derrick

Title: Re: Canopy Holes
Post by: anthony on February 03, 2018, 06:15:13 AM

mine were a perfect fit also , but the edges were sharp and i went through all the spares in a couple of flights so i sanded the edged of the canopy so they didn't cut the grommets