March 29, 2024, 01:14:55 AM

Author Topic: Bell Crank Assembly  (Read 3443 times)

Offline Kevin Feil

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2100
Re: Bell Crank Assembly
« Reply #15 on: January 12, 2013, 12:39:18 AM »
i run nothing but JR, I use this,, SBE-1 CGY750 SBUS ADAPTER FOR NON-FUTABA RECEIVERS.  go to rons heliproz south and look under gyros, you will find it. Or call and speak to Ron and tell him Kevin from Synergy sent you, He will take care of you with what you need!!! I have to run a ar7000 reciever with mine but for me to retool to futaba would cost me a small fortune.. for me the little bit of extra wiring is well worth the performance.. You wont regret it. ;)

Kevin
Team Synergy
Team Futaba
Team Scorpion
Team Morgan Fuels

Offline Chris McClard

  • Newbie
  • *
  • Posts: 27
Re: Bell Crank Assembly
« Reply #16 on: January 13, 2013, 12:11:24 PM »
Is the set up a lot easier then the Vbar? Also does the CGY750 have a Gov? Do I have to run a special servo for the tail or will my Torq BL9188 work, would I have to run a regulator? Just tring to think of all the questions before I make a move for one, cause I have another heli that I can put the Vbar in.
Chris McClard
Fly It Like You Hate It!!!
Synergy N9, Synergy N5c, Synergy 516, Goblin 700, Trex 600E Trex 500 Pro, Trex 250 Pro, Raptor 50, MD 500E with Trex 500 guts, Beam E4.

Offline Kevin Dalrymple

  • Field Representative
  • Sr. Member
  • ****
  • Posts: 397
Bell Crank Assembly
« Reply #17 on: January 13, 2013, 12:49:16 PM »
The set up is different than Vbar. It dose not use a computer. You do not need a regulator and you can run any servo with the 750. Yes it has a gov and it works better than any other system out there today.
Synergy Field Rep
Rail Blades Field Rep

flyalan

  • Guest
Re: Bell Crank Assembly
« Reply #18 on: January 13, 2013, 01:50:04 PM »
You can actually using the SBE-1 adapter.  Didn't realize you already have a VBar ready to go.

Alan