March 29, 2024, 09:31:42 AM

Author Topic: N5c main shaft bearing  (Read 1029 times)

Offline bgymr

  • Newbie
  • *
  • Posts: 38
N5c main shaft bearing
« on: May 05, 2016, 02:49:41 PM »
So the bearing is a 10x19x6.  Mine is a little notchy.  I don't have a spare but have a few 10x19x5.  I don't see the big deal in a mm to limp by until I order my next order. 

I looked and the Gobby 570, Logo 600sx and trex 600 all use a 10x19x5 top main bearing. 

I expect it to last less, but I don't see a hurt in it.  Any input?
« Last Edit: May 05, 2016, 02:52:44 PM by bgymr »

Offline Mike Spano

  • Synergy Hero
  • **
  • Posts: 1038
Re: N5c main shaft bearing
« Reply #1 on: May 05, 2016, 03:46:52 PM »
the balls in the 6mm are larger. the n5c only having 2 main bearing blocks instead of 3, it needs the stronger/larger bearings.

it can also cause miss alignment issues with the large and small spur gears (1mm to be exact :) )
Team Synergy
Rail Blades
TRM Power
Team Byron Fuels
MKS Servos

Offline Richard Rollins

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 553
Re: N5c main shaft bearing
« Reply #2 on: May 05, 2016, 09:04:25 PM »
I agree with Mike, You only need to replace the correct size bearing for the N5c. Nitro tends to Vibrate , with that you will have a lot of bearing movement if not the correct one.

Rick
Team Synergy Team Rails, Team Scorpion