March 29, 2024, 12:01:56 AM

Author Topic: blade holder with tail cover  (Read 1021 times)

Offline Grimmy

  • Field Representative
  • Full Member
  • ****
  • Posts: 204
blade holder with tail cover
« on: April 11, 2017, 03:24:05 PM »
So I've seen one in person, modify their existing blade holder to fit over the tail cover.  Just curious if everyone is just cutting some foam out so it will fit, or are you using a different one?  I wish there was one made for if you use the tail cover.  Maybe it's in the works.

Offline cml001

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 684
Re: blade holder with tail cover
« Reply #1 on: April 12, 2017, 05:19:08 AM »
Just cutting it out the regular Synergy holder..
Clay
I can fly helicopters... Upside down!

Offline Kevin Feil

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2100
Re: blade holder with tail cover
« Reply #2 on: April 12, 2017, 08:59:33 PM »
Also , once cut add a slit on both "lower legs" of the blade holder to where you can attach a rubber band to loop under the tail boom cover and to the opposite leg to hold in place.

K
Team Synergy
Team Futaba
Team Scorpion
Team Morgan Fuels

Offline Mark_NC

  • Newbie
  • *
  • Posts: 16
Re: blade holder with tail cover
« Reply #3 on: April 22, 2017, 07:29:38 AM »

I wasn't sure if the Synergy holder would fit... I ended up buying a Goblin 700 holder (!) which works fine. Just need to scratch-off that logo.... ;)