Synergy Electric Helicopters > Synergy 766
766- a couple of questions :)
exiged:
Hi,
Is a 38mm motor shaft (6mm diameter) long enough for this heli?
Does the kit come with cyclic servo horns?
thanks
curmudgeon:
It should be. I used a 40mm long motor shaft, and it stuck out past the pinion support bearing by quite a bit.
Wolf51:
Then kit includes carbon fibre servo arms and screws for cyclic that fit on a standard futaba "D" servo wheel. The futaba horns are not included. You can choose to use other servo horns.
Sent from my GT-I9507 using Tapatalk
cml001:
What they said..
exiged:
Thanks chaps. I assume the plastic D horns are ok for 3d?
Navigation
[0] Message Index
[#] Next page
Go to full version