March 28, 2024, 08:13:53 PM

Author Topic: 766- a couple of questions :)  (Read 1627 times)

Offline exiged

  • Newbie
  • *
  • Posts: 7
766- a couple of questions :)
« on: August 06, 2017, 10:16:15 AM »
Hi,

Is a 38mm motor shaft (6mm diameter) long enough for this heli?

Does the kit come with cyclic servo horns?

thanks

Offline curmudgeon

  • Synergy Veteran
  • *
  • Posts: 578
Re: 766- a couple of questions :)
« Reply #1 on: August 06, 2017, 10:56:54 AM »
It should be.  I used a 40mm long motor shaft, and it stuck out past the pinion support bearing by quite a bit.

Offline Wolf51

  • Full Member
  • ***
  • Posts: 218
Re: 766- a couple of questions :)
« Reply #2 on: August 06, 2017, 04:27:35 PM »
Then kit includes carbon fibre servo arms and screws for cyclic that fit on a standard futaba "D" servo wheel. The futaba horns are not included. You can choose to use other servo horns.

Sent from my GT-I9507 using Tapatalk

Offline cml001

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 684
Re: 766- a couple of questions :)
« Reply #3 on: August 07, 2017, 06:37:16 AM »
What they said..
Clay
I can fly helicopters... Upside down!

Offline exiged

  • Newbie
  • *
  • Posts: 7
Re: 766- a couple of questions :)
« Reply #4 on: August 07, 2017, 12:49:19 PM »
Thanks chaps. I assume the plastic D horns are ok for 3d?

Offline Wolf51

  • Full Member
  • ***
  • Posts: 218
Re: 766- a couple of questions :)
« Reply #5 on: August 07, 2017, 04:48:39 PM »
Thanks chaps. I assume the plastic D horns are ok for 3d?
Matt designed the servo arms for them.
I take that as a yes


Sent from my GT-I9507 using Tapatalk


Offline Rodney Kirstine

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 2112
Re: 766- a couple of questions :)
« Reply #6 on: August 07, 2017, 06:07:49 PM »
Yes, the idea is that the splines in the plastic horn act as a sort of fuse and should strip before the servo gears do.
Rodney

Team Synergy