January 20, 2018, 10:26:42 PM

Author Topic: Oh yeah Synergy  (Read 383 times)

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2700
  • Admiral, There be whales here!
Re: Oh yeah Synergy
« Reply #15 on: January 03, 2018, 06:10:20 PM »
No the scew and nylon nut on the tt end is fine.


Sent from my iPhone using Tapatalk
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Damper

  • Newbie
  • *
  • Posts: 17
Re: Oh yeah Synergy
« Reply #16 on: January 08, 2018, 10:41:21 AM »
Finished the Assembly, installed the servos , one slight error, I recently purchased a BK Mini servo and the

 the motor that sticks out  of the servo case did not fit the servo square on the the frame, so had to file a little

hump on each side of the rectangle on the frame for that particular servo to fit. It is the BK 5005 HV mini servo

Overall this nitro Kit is extremely enjoyable to assemble. Now for the electronics , receiver, battery, servo

setup.  Looking good for not this weekend but the following one for the maiden flight.  ;D 
It is all about ground clearance

Offline Rodney Kirstine

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 2021
Re: Oh yeah Synergy
« Reply #17 on: January 08, 2018, 12:40:28 PM »
Nice!
Rodney

Team Synergy

Offline cml001

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 656
Re: Oh yeah Synergy
« Reply #18 on: January 08, 2018, 03:28:51 PM »
Werd!
Clay
I can fly helicopters... Upside down!