Synergy Electric Helicopters > Synergy 516
frustrated ball links
tchurco:
Any suggestions on easier link assembly?
TheBum:
I use the circular notch in my ball link pliers to hold the rod and then tools similar to these to relieve the stress on my fingers while screwing on the ball links:
https://www.amazon.com/dp/B00DRE8THW/
dhoskins26:
They are also turn buckles one side is left thread the other is a right thread
Sent from my iPhone using Tapatalk
Matt Botos:
I usually chuck the link rod in a drill and run the rod in and out of the plastic link a few times. Dhoskins26 mentioned a very important piece of information.... make sure you left the left and right threads correct or you will never thread them on properly.
Sent from my iPhone using Tapatalk
tchurco:
thats what I was doing wrong got it now thanks
Navigation
[0] Message Index
[#] Next page
Go to full version