Synergy Tech Support
Synergy Electric Helicopters => Synergy 766 => Topic started by: turner2 on January 20, 2017, 08:52:31 AM
-
Will you get the same results running Gyro + Throttle on the CGY750 running throttle curves or should I run throttle curves on the RX channel 3
-
Mind giving a more detailed explanation of your question?
-
Should I run the ESC through the cgy750 or through the receiver on channel 3 to set throttle curves?
-
Gyro+THR sets the CGY to pass the throttle signal through and the CGY governor is disabled.
Pages 5 and 12 of the CGY v2 firmware manual discuss this.
You can plug the throttle into either the CGY or the receiver.
I elected to plug my throttle into the CGY as it is one of two BEC connections from my ESC and it is a physically cleaner wire layout for me. Also it decreases the complexity of having to remember I did something a little odd during setup of the heli. Last but not least the other BEC wire from my ESC does run to my receiver but is not a throttle input for my ESC.
Hope that helps, and happy building!!!
Robert
-
That's what I was thinking, Thanks Robert!