Synergy Tech Support

Synergy Electric Helicopters => Synergy E5 => Topic started by: larry v on October 25, 2017, 01:30:03 PM

Title: Transmission question
Post by: larry v on October 25, 2017, 01:30:03 PM

I finally got my E5 yesterday just before work. I had just enough time to open it up and look at the parts.
I noticed that one of the trans screws was floating around in the bag so I opened it up to re install it. While I  had it in my hand I spun the gears and found that it spun freely through half of the rotation and was binding through the other half.
So before I get a chance to tear it down I'd like to ask if the gear mesh is adjustable?

Thanks

Title: Re: Transmission question
Post by: Grimmy on October 25, 2017, 02:50:17 PM

Not really.  The only movement to adjustment is the play in the holes themselves, but it's such a super small amount.  If I can remember right, mine wasn't super smooth at first, but after the first flight it was.  I guess it depends on how rough it is.

Title: Re: Transmission question
Post by: cml001 on October 25, 2017, 06:18:31 PM

A few flights should smooth it out.

Title: Re: Transmission question
Post by: larry v on October 26, 2017, 01:15:11 PM

Thank you gentlemen. I'll start with the trans. I'll get it tore down and look it over real good. if I don't find anything obvious I'll fly it and keep an eye on it.

Thanks again,

Title: Re: Transmission question
Post by: RichH on November 01, 2017, 01:26:49 PM

Make sure the gears are pressed all the way into their seats. I suspect that is what will fix the binding.


Sent from my iPhone using Tapatalk