Synergy Tech Support
Electronics Setup Information => Setup Info => Topic started by: Richard Rollins on April 20, 2014, 12:18:17 PM
-
I am having a time getting this to work since I changed to the SBUS2 rx. 7008sb.. Anyone have some info on how to control the SWITCHGLO Pro on a switch say SC like I had it with the 6008?
Thanks,
Rick
-
Rick,
For example: On a Vbar you would plug the Switchglo Pro into the Aux 2 port and assign the Aux 2 channel 5. Then on the TX you would go to the Function menu, associate channel 5 with Auxiliary 2 and assign a switch.
Hope this helps.
Cheers,
Mark
-
I switched channel 3 (throttle) with channel 11 (aux1), I assigned switch SA and the Dip switch position is 1on 2off 3on 4off on the switch glo. Which will give you the tx and beep. I had a hell of a time getting switchglo working like I wanted with 14sg. I couldn't get it to work on channel one or two. Hope this helps.
-
Yes. Unless your FBL unit can output an Aux Channel you need a 7008SB.
You can use a SBD-1 SBus decoder also which will output 3 channel from SBus independent of the FBL unit.
Cheers
Alan
-
I am running R7008sb receivers with CGY-750s on both my nitro helis and have the swtchglo pro plugged into the receivers.
When I was using an SK540 on my N5C, I had the swtchglo pro plugged into the extra swash servo port on it because it would output as aux2 when the swash type was set to a 3-servo type.
Sent from my MotoX via Tapatalk2
-
Thanks for the replys. Jon can you elaborate on how you moved the throttle channel from 3 to 11 ??what menu you used ? I have been working on all suggestions. MJ aux2 is assigned to my GYRO on my vbar can you elaborate on your setup?
Thanks Again.
Rick
-
Ok,, Got it to work with MJ,s setup. Man that was really simple . I feel like a retard now.. hahaha.Thanks for all the replies. Its time to do some heli flying now. Hopefully see all you at IRCHA .
Rick
-
Glad it worked out Rick.
Cheers,
Mark
Sent from my iPhone using Tapatalk 2