Synergy Electric Helicopters > Synergy 516

What are your 516 VBAR settings?

(1/1)

firefighternickn:
Right now, my gain for cyclic is around 60, but my tail is around 92. Not getting a wag on the tail, but its not holding as tight as I thought it should be. Is this too high for gains?

smittylube:
Late reply,
I would first ask what head speeds you are running. If its lower the speedup pulley can help a bunch.
Other things to consider are servo speed and torque and is everything silky smooth travel.
Also the governor can mess with the tail at times.

Grimmy:
Make sure you've done the first 5 steps: https://www.vstabi.info/en/node/2043

I run low headspeed, 1700, 1900, 2050 and I went through the general tweaking order, from the link above, and the tail was rock solid.  I am running the speed up tail as well, due to my low head speeds.  It should be your stop gains too.
 

Navigation

[0] Message Index