Other Manufacturer > General Heli Support
sk 540 and my e5
cafediablo:
I had setup the gov.in the sk540 on version 3.15,..and it was good it gave me th three desired headspeeds that I needed,...I updated to version 3.31 and now it just goes one full speed,...no changes ,....where did I go wrong,...and how can I test if the rpm sensor is functioning.?
Rodney Kirstine:
It's the 3.31 firmware causing it. It got broken in 3.30 and 3.31 was supposed to fix it. Mine still doesn't work, either. If you send the serial number of your SK540 to Skookum support and tell them you want to go back to 3.15, they can set up their server so that the next time you check for updates, it will roll you back to 3.15.
cafediablo:
man this stinks,..I got this 540 used ,..it didn't come with a box ...so no number to go off of,..now what to do?
Rodney Kirstine:
--- Quote from: cafediablo on March 02, 2013, 09:57:06 PM ---man this stinks,..I got this 540 used ,..it didn't come with a box ...so no number to go off of,..now what to do?
--- End quote ---
When you plug it into your PC with the USB cable and run the Skookum Gyro setup software, the unit's serial number is displayed in the upper-right corner of the window.
cafediablo:
I had emailed skookum on this subject and they replied that they could roll back the 3.31 to 3.15 ,,.but not without corrupting my 540,...so I oppted not to reverse the update,...they also mentioned that a newer revision should be coming ,...I'll just be patient and wait.
Navigation
[0] Message Index
[#] Next page
Go to full version