Synergy Tech Support

Synergy Electric Helicopters => Synergy 766 => Topic started by: exiged on September 30, 2017, 11:13:09 AM

Title: xnova 4530 or XTS 4530
Post by: exiged on September 30, 2017, 11:13:09 AM

Im looking to start my 766 build shortly and have been looking at the xnova 4530-500.

Im assuming the XTS 4530-525 would be a little more powerful and power hungry?. Im not looking to go crazy as only running 45-90c packs in 12s config, but still obviously want a capable machine for hard sport/ mild 3d.

160 esc and 766 blades.

Title: Re: xnova 4530 or XTS 4530
Post by: Rodney Kirstine on September 30, 2017, 11:51:08 AM

I run the 4530-500 in mine with a CC 160HV and 766 and it's more than capable for the type of flying you are talking about and with good flight times.

Title: Re: xnova 4530 or XTS 4530
Post by: exiged on October 01, 2017, 05:45:38 AM

Quote from: Rodney Kirstine on September 30, 2017, 11:51:08 AM

I run the 4530-500 in mine with a CC 160HV and 766 and it's more than capable for the type of flying you are talking about and with good flight times.

cheers fella

Title: Re: xnova 4530 or XTS 4530
Post by: Grimmy on October 01, 2017, 07:06:20 AM

The XTS will have thicker wire in the windings.  I went that way figuring it would run cooler, and the power is there if I need it.  I'm getting 8 minutes on my 806 with that motor.  This winter it will get telemetry installed on it and I'll be able to fly longer.