Synergy Tech Support

Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: nickwap on January 02, 2012, 09:12:43 AM

Title: N5c Switch ?
Post by: nickwap on January 02, 2012, 09:12:43 AM

I have a switch mounted in the stock position, where do I get fingers to use it with the canopy on? ???

Or do I need to fit a pin switch.

Don't mind either way, just wondering what everybody else does.

Nick

Title: Re: N5c Switch ?
Post by: Kevin Feil on January 02, 2012, 11:26:06 AM

Nick,

 If you have a Dremel handy just slot a hole on the right side of the heli like the N9 canopies where.  I have done both, I use a Pin switch on one and slotted a hole on the othe.  Take some Blue tape or masking tape in general and try to line it up as best as possible and put the tape on the canopy and draw it out. Make your cut with the Tape still on. this will help minimize paint chips or flaking.  Good Luck! ;D

Kevin

Title: Re: N5c Switch ?
Post by: nickwap on January 03, 2012, 10:37:56 AM

Thanks for that Kevin,
I have a pin switch in 'stock' so I think I'll use that, seems a shame to cut such a nice canopy :)

Title: Re: N5c Switch ?
Post by: Kevin Feil on January 03, 2012, 10:34:30 PM

I know what you mean!!! Good Luck Brother!! ;)

Kevin