Synergy Tech Support
Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: Terryla on December 06, 2015, 04:14:28 PM
-
I followed the manual on installing the tail rotor pitch arms but it seems to be very very tight.i was wondering if it would be alrite to use a ball sizing tool on the pitch arms.thanks for any feed back on this
-
Yes. Just a little at a time.
-
Also make sure the PC arms are not installed backwards ( flipped 180) I have seen this happen before.. Double check before you begins sizing..
BR,
K
-
I did on mine. They were pretty tight too. Much better after a little sizing.
-
I had to resize mine on both my N7 and E5. Not much at all on either Heli.
ROG