Other Manufacturer > General Heli Support

ball link and linkage rod

(1/1)

RC777:
Anybody has a problem with the linkage rod fitting into the ball link. I try all the combinations of the linkage rod and ball link doesn't fit at all. Again, I'm new to Synergy products!

Thanks.

Branden Wheaton:
Send Matt an Email and he will get you taken care of.

steffgiguere:
Yes send mail to Matt, unfortunately some of the kits have bad rods, but problem has been taken care of for the next batches...

Yanick Larouche:
Hi RC777 !

And, if you have die, It's easy to make the thread yourself too !

I do mine and it take about 10 min.

You only need die M2.5 x .45

You have to grind the end of the rod at 45 degré.

and pass the die on the rod.

After, all work # 1.

Don't try to put your plastic link on the rod before do that. You can ruine your plastic link !

 :)

Thank's !

Yanick

Navigation

[0] Message Index