Synergy Tech Support

Synergy Electric Helicopters => Synergy 766 => Topic started by: Manyc on February 07, 2016, 02:23:41 AM

Title: Build help
Post by: Manyc on February 07, 2016, 02:23:41 AM

Hello..  I have managed to score my kit already and have started the build..  However the shim that is meant to go between the auto hub and the bottom bearing block will not fit...

Any ideas?

Thanks

Title: Re: Build help
Post by: Chris Sexton on February 07, 2016, 06:04:55 AM

It is tight on purpose. The bearings need a little preload. The easiest way is to loosen the lower bearing block, insert the shim and tighten it all up. Once the blocks are snug down it will spin free and you're thrust bearings will be happy.


Sent from my iPhone using Tapatalk

Title: Re: Build help
Post by: Manyc on February 07, 2016, 01:07:50 PM

Thanks... Will try tonight..  Build is coming along (http://uploads.tapatalk-cdn.com/20160207/ac68dcd8e843f913ef5b405bd38d8e1c.jpg)

Title: Re: Build help
Post by: Manyc on February 08, 2016, 01:54:47 AM

Thanks worked a treat..  There is zero play in the main shaft..