Electronics Setup Information > Setup Info
Tail Rotor Blades
jayster10:
I was looking for information regarding recommended tail rotor blades for the NC5. Information says 85-95mm blades and just wanted to get feedback of the Rail R-96 blades would work well with an OS .50 sx-h? I also was planning on running the Rail R-606 main blades.
thanks,
Jay
steffgiguere:
Rail 96 works great on the N5c.
jayster10:
Ok, sounds good.
Thank you.
Mike Spano:
I run 106mm tails on mine with 606mm mains. They fit, you just have to be careful when pinning the boom and tail box, you have to back them off a few mm.
cml001:
Same here.. 606/106
Navigation
[0] Message Index
[#] Next page
Go to full version