Synergy Tech Support

Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: jayster10 on January 19, 2016, 11:54:43 AM

Title: Tail rotor play
Post by: jayster10 on January 19, 2016, 11:54:43 AM

Is there suppose to be play in the tail rotor grips? I have about a mm or so if axial play.


Sent from my iPhone using Tapatalk

Title: Re: Tail rotor play
Post by: Mike Spano on January 19, 2016, 12:18:36 PM

yes sir. to help them track properly.

Title: Re: Tail rotor play
Post by: jayster10 on January 19, 2016, 06:10:53 PM

Ok. I was hoping it was suppose to be like that instead of something I did.


Sent from my iPhone using Tapatalk

Title: Re: Tail rotor play
Post by: Mike Spano on January 20, 2016, 07:52:46 AM

yes sir. its very important too. so after you re-build it a few times, you may notice that it has disappeared. when that happens, its usually due to lock tight buildup on the M3 washer that the bolt goes though to hold the grip onto the hub. if that happens, remove the bolt and washer, and clean it up to look brand new, or simply replace it with a new bolt and washer, and the it will likely come back just fine. took me a few times of looking into it to figure that out.

Title: Re: Tail rotor play
Post by: jayster10 on January 20, 2016, 08:23:40 AM

Ok. Thank you for that info. By the way, do you know where I can get rotor blade shims. I have 600mm with 12 mm root. So there is about a 2 mm gap between grip and blade. Can I use regular washers?


Jay L.

Title: Re: Tail rotor play
Post by: Mike Spano on January 20, 2016, 10:13:13 AM

they usually come with Rail Blades in the package. honestly, I don't know where to order them from, but if you will PM me your address, I will send you some to use. I have a crap load of them.

Title: Re: Tail rotor play
Post by: jayster10 on January 20, 2016, 10:42:35 AM

Ok. Awesome. You Rock.


Jay L.