May 08, 2024, 05:57:23 PM

Author Topic: RECEIVER PACKS  (Read 5647 times)

Offline Rodney Kirstine

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 2112
Re: RECEIVER PACKS
« Reply #30 on: March 16, 2014, 11:36:35 AM »
Yes that is the GensAce I'm using. Very satisfied...decent price and about 10 flights per
pack with my setup.

I'm using that one, as well, and also get about ten flights.

Sent from my MotoX via Tapatalk2

Rodney

Team Synergy

Offline Roger

  • Full Member
  • ***
  • Posts: 221
Re: RECEIVER PACKS
« Reply #31 on: March 16, 2014, 12:55:33 PM »
I read that pack as a 1c continuous and 10c burst discharge rate.  Is there reason to be concerned about those low numbers or for servo and Rx use is that plenty.  On an electric I understand the battery is powering the motor and the control electronics and therefore needs much higher current capability. 

R.O.G.
ROG
Retired Old Guy

Offline cyprusflyer

  • Full Member
  • ***
  • Posts: 112
Re: RECEIVER PACKS
« Reply #32 on: March 16, 2014, 02:29:58 PM »
I read that pack as a 1c continuous and 10c burst discharge rate.  Is there reason to be concerned about those low numbers or for servo and Rx use is that plenty.  On an electric I understand the battery is powering the motor and the control electronics and therefore needs much higher current capability. 

R.O.G.

Not a problem, my TDR a 700 size electric has logging on the Kosmic, I have 5.6V BEC, point is that the servos normally draw 3-4A with peaks at 10A. Therefore a 4000mapack would be 1C most of the time and 3C peak worse case say.
Trex 550E
Logo 500SE - 600SX
SynergyE7, N5C and N7
zzzzzzzzzzzzzzzTDR