Synergy Tech Support

Synergy Nitro Helicopters => Synergy N7 => Topic started by: sheva99 on June 27, 2016, 09:41:59 AM

Title: N7 Governor Sensor (GV-1) Mounting issues
Post by: sheva99 on June 27, 2016, 09:41:59 AM

Mounted GV-1 Sensor on plastic bracket on clutch stack.  Bracket does not have any adjustment for movement of sensor. 
Unable to mount with two screws on GV-1 to bracket.

Sensor is so close to clutch bell I am afraid it is going to hit magnet.

Has anyone had this issue,  and what was the fix?

Thanks..

Title: Re: N7 Governor Sensor (GV-1) Mounting issues
Post by: Mike Spano on June 27, 2016, 11:12:57 AM

i use the same pickup and magnets. no issues. I only install with 1 bolt, and I have never had one come out before. I have never had issues with the magnets hitting the sensor either. I have had a magnet begin to creep up one time and it took some of the plastic off the end of the sensor, but it didn't damage it and I have not had any issues when the magnets have been properly secured in the bell.