Hi, I just purchased the N7 kit about two weeks ago while attending the Mid America Funfly in Michigan. I just started the build last night and I ran into a problem on page 8 of the manual. The wrong screws are installed into the frame spacers (310-110). They have M2.5x6 CAP HEAD screws installed where M2.5x6 cross recessed screws should go. I checked through the ENTIRE kit, none of those screws are floating around elsewhere. My problem is that i went to two hardware stores to see if they had them-they don't carry them that small. I went to the hardware store because the local hobby doesn't have them in stock. So I looked the part number on the Synergy store....it shows that part number as being a cap head screw even though the manual says it's a cross recessed screw. I looked up the a previously installed crossed recess screw M2.5x6 and it showed a different part number of 103-256 (page 7 of N7 manual). so, I am guessing I need 6 of 103-256 instead of 6 of 100-206. I don't mind paying a couple of bucks for screws, but just by barely. However I don't really want to pay those shipping fees for six screws! I looked up other post and Matt stated to email him if there is missing parts from the kit and that they will get them out asap. I looked under Contact on the Synergy home page and it directs me to the forum.
I need 6 M2.5x6 cross recessed screws part number 103-256, can someone supply me with Matt's email that he uses for this stuff?
Many Thanks!
Ed Hackman
eghackman@yahoo.com
