May 04, 2024, 10:02:37 AM
« previous next »
Pages: 1 2 [3]

Author Topic: Can't get the bolt out of the head axle  (Read 7932 times)

Offline NKY Heli Guy

  • Full Member
  • ***
  • Posts: 164
Can't get the bolt out of the head axle
« Reply #30 on: December 31, 2012, 05:16:16 PM »
Guys I have not tried it but can't you put a soldering iron on it to loosen red locktight up? Heat that is :)


Sent from my iPhone using Tapatalk
Logged

Offline Brandon Bartolomucci

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 1007
Can't get the bolt out of the head axle
« Reply #31 on: December 31, 2012, 06:19:27 PM »
Yes in general heat will loosen things up for you. A soldering iron will be the most direct but warming with a heat gun would probably also work but may take longer.


Regards,
Brandon Bartolomucci
Sent from my iPhone
Logged
Regards,
Brandon Bartolomucci
Team Synergy; Scorpion; & Bavarian Demon

Offline NKY Heli Guy

  • Full Member
  • ***
  • Posts: 164
Can't get the bolt out of the head axle
« Reply #32 on: December 31, 2012, 10:11:00 PM »
Thank you, I thought that was true but just wanted to clarify.


Sent from my iPhone using Tapatalk
Logged

Offline RichL

  • Synergy Veteran
  • *
  • Posts: 802
Re: Can't get the bolt out of the head axle
« Reply #33 on: December 31, 2012, 10:16:13 PM »
You need two "T" handled hex drivers of good quality and a little heat.  They will pop loose!

Rich
Logged
Synergy E5: Scorpion HKIII 4025-1100, CC ICE2 120HV, Rail 556/96, V-Bar Silverline

Synergy E7: Quantum 4530-500, CC ICE2 160HV, Rail 716/116, V-Bar Silverline
Pages: 1 2 [3]
« previous next »