May 03, 2024, 12:52:12 AM
« previous next »
Pages: [1]

Author Topic: Rear plate above tail boom  (Read 1426 times)

Offline mc20piece

  • Newbie
  • *
  • Posts: 27
Rear plate above tail boom
« on: April 17, 2015, 01:06:41 PM »
Can a gyro/receiver be mounted on the rear plate on the N7? With the new Vbar Neo coming out the unit has to mounted flat even when using an external sensor. In the event the external sensor malfunctions it fails over to the internal sensor and the bailout function always uses the internal sensors. So, I was wondering if I could mount a Gyro/Receiver on that rear plate?
« Last Edit: April 17, 2015, 01:22:30 PM by mc20piece »
Logged

Offline steffgiguere

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 1373
Re: Rear plate above tail boom
« Reply #1 on: April 17, 2015, 01:20:43 PM »
Sure can. In front in back any flat surface on the any Synergy can accommodate your FBL gyro.
Logged
Team Synergy, Canada

Offline mc20piece

  • Newbie
  • *
  • Posts: 27
Re: Rear plate above tail boom
« Reply #2 on: April 17, 2015, 01:25:33 PM »
It just seems it wasn't designed for that by looking that cut outs on it and the spacing between support would have more vibes than the front mount. Anyone have their Gyro mounted there?
Logged

Offline Rob Cherry

  • Factory Pilot
  • Sr. Member
  • *****
  • Posts: 341
Re: Rear plate above tail boom
« Reply #3 on: April 20, 2015, 10:37:35 PM »
Nope, no vibes. You will be good to mount any gyro on that plate if so desired. The 2mm cf only spans a short distance. Go for it!  :)
Logged
Synergy Factory Pilot

Offline Ben Kerr

  • Field Representative
  • Sr. Member
  • ****
  • Posts: 307
Re: Rear plate above tail boom
« Reply #4 on: April 20, 2015, 11:37:35 PM »
The only down side to mounting anything back there is it will be exposed to the nitro smoke. Tucking everything under the canopy helps keep it free of oil and the center of gravity correct.
Logged
Team Synergy / Rail Blades / Scorpion Power Systems/Thunder Power

Offline Mark Burberry

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 662
Re: Rear plate above tail boom
« Reply #5 on: April 21, 2015, 01:24:40 AM »
I am with Ben on the nitro residue at the back.

If it were me trying the Neo, an option would be to use another Gyro mount plate under the existing one. You should be able to mount it to the existing frame spacers. One on top and bottom. Part # 310-104

That way you could have the Neo on the top and the external sensor underneath.

Mark
Logged
Pages: [1]
« previous next »