Synergy Tech Support
Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: Tradhunt on October 18, 2011, 11:16:28 PM
-
Well I have been wanting to get one for a while to test out and see how I like it compared to my current and past heli's. I'm really looking forward to flying it. I was planning on getting a E6/7 but that will be next.
Setup will be.
N5C FBL
YS56/Funtech pipe
BLS451's cyclic
JR 8900G tail
Blades I'm going to pick up some Rail's
FBL unit not sure yet but will probably go with the CGY750 or Vbar as I have both here. Leaning towards the CGY750.
-
Congrats! Whether you are a grandpa flier like me or a smack person like 95% of other people I think you will love his heli. None of my previous helis have felt so tight and together as my N5c. Post up some pictures of your progress and/or finished build if you get the. chance!
Regards,
Brandon Bartolomucci
Sent from my iPhone
-
Thanks Brandon.
Will do on the pic's. Looks like it will be here on the 25th..... Gonna be a long few days ;D
-
Do you already have a Synergy? If not, after first flight, you will be very glad you finally have one.
-
Nope first one. I'm sure I wil like it.
-
Congrates George,
Make sure you check out the Build TIPS/TRICKS post Matt has on the Forum. It will be very Beneficial to you and the Build!! Pay close attention to the Tail shaft Mesurments and start shaft alignment. We want photos ASAP when you get her finished and Flying. Good Luck
Kevin
-
Just an FYI, make sure you go in and take the head apart and the tail grips apart. On my kit, none of the thrust bearings had any grease in them what so ever. That could have ended badly.
-
Thanks Kevin.
I've read through some of it but will look it all over.
Thanks Brandon. I have always pulled things apart to locktite and re grease everything when I get a kit. I have been keeping up on the threads as well.
-
Good Luck with it Brother!! 8)
Kevin
-
Congrats and welcome to the family!!
Matt
-
Thanks Matt.
So far its going good. Servos and CGY750 installed and somewhat programed.
Just gotta work on the engine as it seems like it doesn't want to line up/fit right. Engine washer is installed but it doesn't seem to be enough as the slutch sticks out below the bell oretty good and the fan is hitting the shroud.
-
Ok here's a few pic's. Maiden tomorrow.
Setup..
N5C
YS56SR
Funtech pipe
BLS451's cyclic
JR 8900G tail
CGY750
R6203SB rx
Rail 606 mains
Rail 96 tail
[attachment deleted by admin]
-
Very nice. I think we all expect a full report on how much you like it haha. Good luck on the maiden! She should serve you well.
Regards,
Brandon Bartolomucci
Sent from my iPhone
-
So far not much time on it yet. Had a few tuning flights on it thats about it.
Raining now so maybe more next week.