Synergy Tech Support
Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: turner2 on June 30, 2017, 09:53:08 AM
-
I just built an n5c install the ball on the servo horn in the proper hole binds on the mid range needle valve. I had to move the ball in one hold to correct this. Is this going to effect my tail hold?
-
Did you install the pivot ball on the upper side of the bellcrank?
-
Yes it is on the top. I was wondering if I could twist my carb enough to get clearance
-
Yes rotating the carb slightly is fine. I've had to do that as well.
-
May wanna double check that the tail servo horn is at 90 degrees and the ball is at the correct distance on the horn..
-
Rotated carb tail control rod clears , maiden flight tomorrow , thanks guys
-
Awesome! Glad u got squared away! Ur gonna love this bird... N5C kicks ass!