May 13, 2024, 06:08:57 AM
« previous next »
Pages: [1]

Author Topic: N5c main shaft issue  (Read 1392 times)

Offline GScott

  • Newbie
  • *
  • Posts: 13
N5c main shaft issue
« on: May 14, 2012, 06:47:24 AM »
I noticed over the weekend that my tail pulley (one connected to main shaft) had 1-2mm of back and forth play.  I could hold the head and rotate the pulley back and forth.  When I disassembled everything I noticed that both holes in the main shaft had wallowed out.  I verified that both bolts were correct.  Anyone else notice this?
Logged

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
N5c main shaft issue
« Reply #1 on: May 14, 2012, 07:14:29 AM »
I have a little play in the pulley on my e7. I haven't pulled the head to check the holes.


Sent from my iPhone using Tapatalk
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Brandon Bartolomucci

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 1007
N5c main shaft issue
« Reply #2 on: May 14, 2012, 07:17:17 AM »
I haven't noticed it on mine yet but now I'll double check it when I get home tonight.


Regards,
Brandon Bartolomucci
Sent from my iPhone
Logged
Regards,
Brandon Bartolomucci
Team Synergy; Scorpion; & Bavarian Demon

Offline Matt Botos

  • Synergy Hero
  • **
  • Posts: 1573
    • Matt Botos
Re: N5c main shaft issue
« Reply #3 on: May 16, 2012, 02:22:26 AM »
The main pulley has a split in boss that contacts the main shaft. The bolt should be tightened enough that the pinching mechanism can work. I have never seen adverse side effects from this bolt being too loose but I would highly recommend tightening down the bolt a little more.
If the flat spot that captures the nut is rounded out from tightening you can grab the nut with a pair of pliers.

Hope that helps,

Matt
Logged
Pages: [1]
« previous next »