Synergy Tech Support

Synergy Electric Helicopters => Synergy E7SE => E7SE Tips & Tricks => Topic started by: Matt Botos on October 13, 2011, 08:01:00 PM

Title: Belt Drive E7 - Right Rudder Travel - Do not use all of it!!
Post by: Matt Botos on October 13, 2011, 08:01:00 PM

On the E7 Belt Drive Kit....Do not use all of your right rudder travel. You will stall the tail blades when the gyro is trying to compensate!
Leave a 4mm gap between brass slider and tail box flange bearing. See shitty picture for illustration of correct amount of travel.

Thanks,

Matt

[attachment deleted by admin]

Title: Re: Right Rudder Travel - Do not use all of it!!
Post by: Funky on January 06, 2013, 03:57:16 PM

Is it 4mm from the bearing itself or 4mm from the bearing housing?

I am using the torque tube tailbox if that makes a difference

Title: Right Rudder Travel - Do not use all of it!!
Post by: Kevin Dalrymple on January 06, 2013, 06:44:08 PM

From the bearing to the slider. Hope that helps.

Title: Re: Right Rudder Travel - Do not use all of it!!
Post by: Anthony Oxlade on January 07, 2013, 01:34:26 AM

I believe if you are using the torque tube tail box you need to use all available rudder travel. Matt's recommended 4 mm gap is for the belt drive version.