Synergy Electric Helicopters > Synergy 516
516 to 556
woodscra:
What is a good setup for 6s?
Reuse an existing 1350kv with 16t?
1200kv with 17/18t?
90mm tail blades and 18t tail pulley.
alan:
If you have the 1350 go with it. Should be fine with the 16t pinion. I ran my 516 at a lower than most head speed so when I stretched it I did not change the pinion. I run the pyro 600-1200. I opted for the 20t pulley and kept the 80.6 tail blades.
Cheers
Alan
Sent from my iPhone using Tapatalk
woodscra:
Thanks.
No tail hold problems with the standard tail pulley, 80 blades and lower head speed?
What is your headspeed?
Which pinion?
alan:
No problems at all. My bad. 18t pulley.
1950/2100
Sent from my iPhone using Tapatalk
woodscra:
Which motor pinion?
Navigation
[0] Message Index
[#] Next page
Go to full version