Synergy Tech Support
General => Welcome to Synergy => Topic started by: applesorbananas38 on February 01, 2015, 08:08:48 PM
-
Just became the proud owner of an E7se and I'm lonin it! However, during the course of getting to know the helicopter better mechanically I noticed that the tail pitch links were fitting quite snug on the tail pitch pivot ball. That being said as a result of the links being too snug the helicopter would wag during flight. After going through the tail with a fine tooth comb I realized that the only solution to the tail wag would be to ream the link until I get the silky smooth feeling that that we all look for. Has anyone else experienced a binding in the tail as a result of the links in the tail being too tight?
-
Welcome! All of the links will most likely be too tight when they're brand new. To size them, you'll need to get yourself one of these... http://mattbotos.com/store/index.php?main_page=product_info&cPath=29&products_id=1629 (http://mattbotos.com/store/index.php?main_page=product_info&cPath=29&products_id=1629)
-
To optimize smooth operation of the plastic links, the Synergy manuals recommend using the Boto-Sizer (part 700-001) (http://www.amain.com/synergy-boto-sizer-ball-link-sizing-tool/p221331). The Synergy E7SE manual states it on page 34.
-
Welcome to one of the best helicopter families in existence! As all have said, you need to get you a Boto Sizer. After you size them links, you'll be ready to rock and roll.
Mark
-
Welcome to the Synergy family!
-
Welcome to Synergy!
-
Just don't make them to loose use the sizer, too loose they will come off in flight, mainly on the cyclic. :)
-
Welcome to the Synergy Family
K
-
Welcome .