May 19, 2024, 10:31:11 AM
« previous next »
Pages: [1]

Author Topic: Missing 2.5x6 Cross Head Screws  (Read 1015 times)

Offline TheBigE

  • Newbie
  • *
  • Posts: 45
Missing 2.5x6 Cross Head Screws
« on: May 02, 2015, 10:02:31 AM »
All,

Working through my N7 build right now and seems that I am missing M2.5x6 Cross Head Screws (2x) and rather I had 2x M2.5x8mm in the kit installed in the 310-110 Frame Spacer.    See attached below.   Am I missing parts or is this configuration used elsewhere in the build?  I have looked through the manual to see if I could find another place where the 310-110 Frame Spacers are used.

Seems that I am missing the M2.5x6 Cross Head screw.   



Logged

Offline Barry Tilson

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 617
  • Perspective Visuals
Missing 2.5x6 Cross Head Screws
« Reply #1 on: May 02, 2015, 11:51:45 AM »
I think it goes to the bottom carbon mounting? Mine had it also. Page 23
Logged
Perspective Visuals

Offline Richard Rollins

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 553
Re: Missing 2.5x6 Cross Head Screws
« Reply #2 on: May 04, 2015, 09:32:10 AM »
Morning,

If you are just missing 2 of the 2.5x6  look on page 25 of the manual. One of those 3 braces is the one with the canopy mounts on it. Hope this helps.
Logged
Rick
Team Synergy Team Rails, Team Scorpion

Offline TheBigE

  • Newbie
  • *
  • Posts: 45
Re: Missing 2.5x6 Cross Head Screws
« Reply #3 on: May 14, 2015, 10:26:20 AM »
Yeap - Thanks I found them as I went on with the build.  All is good now!!
Logged
Pages: [1]
« previous next »