Synergy Tech Support
General => Main Helicopter Discussion => Topic started by: Chris Blom on January 29, 2017, 02:34:25 AM
-
So I got a new motor for my 550 EPH.The motor shaft was too long so I cut it with my dremmel.I cut it on the short side by 1/16 of an inch.Do I have to replace the motor shaft now since it does not of the sit flush in the bottom bearing in the bottom bearing FBL Rotor's bearing block?
-
It should be ok as long as you've got about 75% or more engagement in the bearing. Secure the shaft to the bearing with a little loctite red or retaining compound, be careful not to get it in the bearing race.