General > Main Helicopter Discussion

Synergy E5

(1/4) > >>

Brandon Bartolomucci:
Ok so there's some threads on the primary forums about the E5 and people are getting kind of pumped about it. I wondered if it might not be a bad a idea to start a thread here. I mean this is Synergy after all. I'm sure most of us want one and are probably getting one so let's talk about it.

Whether you are posting your planned set up, new information about it, just general excitement whatever it is; If it's about the E5 and it's something to get the blood pumping for this heli, let it fly. Get it STARTED!

I'll be running a set up pretty much like Matt had on the demo with a few changes:
Rail 556 main/96 tails
AR7200BX
BLS255HV cyclic/BLS256HV tail
ThunderPower 65c 4400 pack to start
Scorpion HKIII-4025-1100kV motor
Castle HV120/BEC Pro
DX18

Motor will be here tomorrow and then I'll have everything except the kit, ESC, and battery.


Regards,
Brandon Bartolomucci
Sent from my iPhone

flyalan:

--- Quote from: Brandon Bartolomucci on August 30, 2012, 12:40:44 PM ---Ok so there's some threads on the primary forums about the E5 and people are getting kind of pumped about it. I wondered if it might not be a bad a idea to start a thread here. I mean this is Synergy after all. I'm sure most of us want one and are probably getting one so let's talk about it.

Whether you are posting your planned set up, new information about it, just general excitement whatever it is; If it's about the E5 and it's something to get the blood pumping for this heli, let it fly. Get it STARTED!

I'll be running a set up pretty much like Matt had on the demo with a few changes:
Rail 556 main/96 tails
AR7200BX
BLS255HV cyclic/BLS256HV tail
ThunderPower 65c 4400 pack to start
Scorpion HKIII-4025-100kV motor
Castle HV120/BEC Pro
DX18

Motor will be here tomorrow and then I'll have everything except the kit, ESC, and battery.


Regards,
Brandon Bartolomucci
Sent from my iPhone

--- End quote ---
Hope that would be the 1100kv scorpion. Unless you are going for the low headspeed record :-)
I think I will be ordering the KDE equivalent at 1175kv.
Cheers
Alan


Sent from my iPhone using Tapatalk

Brandon Bartolomucci:
Ah yes thank you. Corrected.


Regards,
Brandon Bartolomucci
Sent from my iPhone

flyalan:
Well after looking at Amy's post on Facebook regarding motor options I may go ahead and use a 4025-550 that I have.  Also have a 435-560 I could use.  All running 12s  on a stretched e5. Decisions decisions.


Sent from my iPhone using Tapatalk

RyanW:
My setup:

Kontronik Pyro 1100kV (if shaft dimensions work)
Kontronik Jive 100+ LV or 120+ HV
V-Bar
Rail 556 main/96 tails
JR 8917 servos w/ BLS 256 tail
Opti-Power 4300mAh 6S packs (you need to try these!)

Navigation

[0] Message Index

[#] Next page