Electronics Setup Information > Setup Info

VBar 5.2 Files: N5c, E6+E7

<< < (2/2)

bkervaski:
I let the VBar software control my tail gain.  With a BLS251 I was around 90, with a BLS256 I'm up to around 100 on both 96mm and 106mm tail blades.

Also, be sure to check out bank switching on the VBar, lets you run completely different VBar configurations on a switch, just be sure to copy your good working base config to the other banks before experimenting.

jmancobra:
ooops, thought i was posting in the esc forum

714SpunOut:
What type of gyro tape/stack up are you using on N5c?

Campbell Brudi:
Bill!!!!

Navigation

[0] Message Index

[*] Previous page