Electronics Setup Information > Setup Info

n5 and beastx

<< < (2/2)

craig1980:
Question for those who are running beast x on the n5c.  What are you using to mount the beast x unit to the heli and how far are your servo balls from center?

Ross Lawton:
Hi Craig,

Most flybarless setups will utilise a ball link spacing of around 10mm/10.5mm on the servo output arms so i would aim to start there with your setup so you can get a good initial mechanical setting.

With regards to tape selection, i don't acutally use a BeastX myself but i know most that do will use either the BeastX foam that has the cut-out in the center (Beast Foam part number: BTXA76008) or a 3M alternative which is slightly thinner, i believe the 3M code for it is (4011).

Hope this helps!
Cheers!
Ross

Navigation

[0] Message Index

[*] Previous page