Synergy Tech Support
Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: birddawgg on June 12, 2013, 09:54:50 PM
-
I've gone through the manual from end to end and I cannot find what the gear ratio is for the 20T pinion to 170T main gear. Can anyone pass that info on?
Thanks, Scott
-
Hi Scott,
The gear ratio would be 8.5:1
Mark
-
Out of curiosity. What heli is that with a 20t pinion and 170t main gear?
Cheers
Alan
-
Must be the N5C Alan
-
Out of curiosity. What heli is that with a 20t pinion and 170t main gear?
Cheers
Alan
My bad. Could have swore I was looking at the E5 section:-)
Alan
-
That's what I thought ;D
-
Thanks for the quick info yet again. It is the N5c, I thought I was posting in the correct forum for this question. Had to Look and verify that I was in the N5/N5c forum. Sorry if I confused anyone.
Scott
-
No problem Scott... Anytime.
-
Scott,
Again my bad. I need to not post after 9pm. I start getting a little punchy ;)
Cheers
Alan
-
I've gone through the manual from end to end and I cannot find what the gear ratio is for the 20T pinion to 170T main gear. Can anyone pass that info on?
Thanks, Scott
FYI, if you have tooth counts, the gear ratio is calculated by dividing the main gear count by the pinion count.
i.e. 170/20 = 8.5
-
Thanks Darren! That info will make into the note book for sure.