Synergy Tech Support
Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: peteowlsmith on June 03, 2015, 04:48:32 PM
-
Finishing off the airframe, and I have 4 extra guests :o
All are stainless steel - 11.90 OD x 8.00 ID . Two are .48 thick ---- two are .78 thick ?
-
did you install your shims in your head? between the damper and the radial bearings on the head axle?
-
:) Yep.
It is like they are "spares" if there is any end play, which there isn't.
-
You are correct. The washers are shown on the fly barred assembly page a46.
There are three sizes to get the play out of the blade grips. (Thin) 106-801 8x.5mmWasher (Med.) 106-802 8x.75mmWasher (Thick) 106-803 8x1mm Washer.
Mark
Sent from my iPhone using Tapatalk
-
phew - I have a FBL unit --- and now some extra washers 8)