Synergy Tech Support

Synergy Electric Helicopters => Synergy E7SE => Topic started by: mahbouni on November 22, 2012, 03:50:43 PM

Title: 8mm Pinions
Post by: mahbouni on November 22, 2012, 03:50:43 PM: Are there any plans to produce pinions with 8mm bore so we can try the Pyro 800-48?
Title: 8mm Pinions
Post by: Chris Sexton on November 22, 2012, 04:06:01 PM: I don't think the pyro 800 fits between the frames. Frame width is 60mm isn't it?

Sent from my iPhone using Tapatalk
Title: Re: 8mm Pinions
Post by: Jean-Luc Bolduc on November 22, 2012, 08:54:55 PM: 62 mm spacing, but 800 is 63mm. You'd have to put washers or spacers to widen frames to make it fit.
Title: Re: 8mm Pinions
Post by: Jean-Luc Bolduc on November 22, 2012, 08:56:11 PM: Pinions could be drilled a bit, not sure if ok to enlarge hole from 6mm to 8mm.
Title: 8mm Pinions
Post by: Chris Sexton on November 22, 2012, 09:13:42 PM: Quote from: 4cyclic on November 22, 2012, 08:54:55 PM
62 mm spacing, but 800 is 63mm. You'd have to put washers or spacers to widen frames to make it fit.

Ahh I was reading the spot for max motor on a different thread. Thanks for the clarification.

Sent from my iPhone using Tapatalk
Title: Re: 8mm Pinions
Post by: Jean-Luc Bolduc on November 23, 2012, 07:55:13 PM: it's a really nice motor, no doubt. Keep us posted if you decide to go and do the trial.
Title: Re: 8mm Pinions
Post by: mahbouni on November 24, 2012, 06:24:49 AM: If the motor is too wide then I'm not going to mod anything. Was just wondering if it will work. There is a Pyro 750 being tested by some pilots over here.
Title: Re: 8mm Pinions
Post by: Matt Botos on December 16, 2012, 12:56:40 PM: The Pyro 750 would be a better option! It will have more than enough power for the E7.

:)