Synergy Tech Support
Other Manufacturer => General Heli Support => Topic started by: RC777 on October 17, 2011, 11:23:31 AM
-
Anybody has a problem with the linkage rod fitting into the ball link. I try all the combinations of the linkage rod and ball link doesn't fit at all. Again, I'm new to Synergy products!
Thanks.
-
Send Matt an Email and he will get you taken care of.
-
Yes send mail to Matt, unfortunately some of the kits have bad rods, but problem has been taken care of for the next batches...
-
Hi RC777 !
And, if you have die, It's easy to make the thread yourself too !
I do mine and it take about 10 min.
You only need die M2.5 x .45
You have to grind the end of the rod at 45 degré.
and pass the die on the rod.
After, all work # 1.
Don't try to put your plastic link on the rod before do that. You can ruine your plastic link !
:)
Thank's !
Yanick