Synergy Tech Support

Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: peteowlsmith on June 03, 2015, 04:48:32 PM

Title: 4 extra washers?
Post by: peteowlsmith on June 03, 2015, 04:48:32 PM

Finishing off the airframe, and I have 4 extra guests   :o

All are stainless steel  -  11.90 OD  x 8.00 ID     .    Two are .48 thick ----  two are .78 thick ?

Title: Re: 4 extra washers?
Post by: Mike Spano on June 03, 2015, 04:59:05 PM

did you install your shims in  your head? between the damper and the radial bearings on the head axle?

Title: Re: 4 extra washers?
Post by: peteowlsmith on June 03, 2015, 06:24:30 PM

 :)     Yep.

It is like they are "spares" if there is any end play, which there isn't.

Title: 4 extra washers?
Post by: Mark Dean on June 03, 2015, 07:03:19 PM

You are correct. The washers are shown on the fly barred assembly page a46.
There are three sizes to get the play out of the blade grips.   (Thin) 106-801 8x.5mmWasher (Med.) 106-802 8x.75mmWasher (Thick) 106-803 8x1mm Washer.

Mark


Sent from my iPhone using Tapatalk

Title: Re: 4 extra washers?
Post by: peteowlsmith on June 03, 2015, 07:46:52 PM

phew - I have a FBL unit  --- and now some extra washers   8)