Synergy Tech Support

Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: Hyp05fxdl on April 26, 2016, 02:19:10 PM

Title: YS 61?
Post by: Hyp05fxdl on April 26, 2016, 02:19:10 PM

Just curious,  will a YS 61 fit in a Nc5?

Title: Re: YS 61?
Post by: Mike Spano on April 26, 2016, 02:41:35 PM

Yes sir.

Title: Re: YS 61?
Post by: Jon Yarger on May 08, 2016, 12:48:39 PM

Are you sure about that? I thought the YS 61 is the same size as a 91? The YS 60 yes but older 61?

Title: Re: YS 61?
Post by: Rodney Kirstine on May 08, 2016, 07:31:25 PM

Yes, it fits just fine. I ran one in mine for a while.

Title: Re: YS 61?
Post by: Jon Yarger on May 09, 2016, 09:18:11 AM

Ok, cool.

Title: Re: YS 61?
Post by: Mike Spano on May 09, 2016, 10:10:20 AM

if it is the same size as a .91 then I don't know....

Rodney, are you sure you ran a .61, and not a .60?

the ys 60 is 17.5mm x 44mm mounting pattern

the ys 61 is 25mm x 52mm

I miss read the original post I did think you meant a 60. I don't think the 61 will fit without modifications.

http://www.ysengines.us/manuals/manuals_old_us/helicopter/61ST2.pdf (http://www.ysengines.us/manuals/manuals_old_us/helicopter/61ST2.pdf)
http://www.ysengines.us/manuals/manuals_us/helicopter/60SR.pdf (http://www.ysengines.us/manuals/manuals_us/helicopter/60SR.pdf)

Title: Re: YS 61?
Post by: Rodney Kirstine on May 09, 2016, 11:44:37 AM

I'm sorry, Mike is right andit was a 60 that I had. Sorry for the confusion.