Synergy Tech Support

Synergy Electric Helicopters => Synergy 766 => Topic started by: Grimmy on April 11, 2017, 03:24:05 PM

Title: blade holder with tail cover
Post by: Grimmy on April 11, 2017, 03:24:05 PM

So I've seen one in person, modify their existing blade holder to fit over the tail cover.  Just curious if everyone is just cutting some foam out so it will fit, or are you using a different one?  I wish there was one made for if you use the tail cover.  Maybe it's in the works.

Title: Re: blade holder with tail cover
Post by: cml001 on April 12, 2017, 05:19:08 AM

Just cutting it out the regular Synergy holder..

Title: Re: blade holder with tail cover
Post by: Kevin Feil on April 12, 2017, 08:59:33 PM

Also , once cut add a slit on both "lower legs" of the blade holder to where you can attach a rubber band to loop under the tail boom cover and to the opposite leg to hold in place.

K

Title: Re: blade holder with tail cover
Post by: Mark_NC on April 22, 2017, 07:29:38 AM

I wasn't sure if the Synergy holder would fit... I ended up buying a Goblin 700 holder (!) which works fine. Just need to scratch-off that logo.... ;)