Synergy Tech Support
Synergy Nitro Helicopters => Synergy N5 / N5c => Topic started by: R6Pilot on April 21, 2018, 05:49:04 PM
-
Hello all,
My N5C is up and running. Love this heli. I've got almost a gallon through it and I'm dialing in the tune. Just in time for summer in the Pacific Northwest!
I do have a concern, the 115-319 Tail Bearing Ring pivot ball has come loose twice. I glued as per instructions using MED CA. I ended up using a 5 min epoxy that seems to be holding. Anyone else have this issue, if so, what was your solution?
Thanks Dave
Thanks Dave
Sent from my SM-N950U using Tapatalk
-
I went to check mine, no sign of coming loose. These types of situation I would have done the same and buy a new assembly, in this case a tail pivot ring and pivot ball on the tail slider ring, for peace of mind. If the ball came loose again and putting 5 min Epoxy, it should not , I replace since I have the parts.
-
I went to check mine, no sign of coming loose. These types of situation I would have done the same and buy a new assembly, in this case a tail pivot ring and pivot ball on the tail slider ring, for peace of mind. If the ball came loose again and putting 5 min Epoxy, it should not , I replace since I have the parts.
Good to hear that yours isn't. I must have stripped it some how. I think I'll put a touch more epoxy on it overnight before I head to field. A buddy of mine checked his after I told him my issue and his was loose as well.
Sent from my SM-N950U using Tapatalk