November 22, 2024, 11:07:10 PM
« previous next »
Pages: [1]

Author Topic: How to replace tail shaft bevel gear?  (Read 1598 times)

Offline Anthony Oxlade

  • Full Member
  • ***
  • Posts: 122
How to replace tail shaft bevel gear?
« on: October 04, 2012, 02:17:28 PM »
Does anyone have any tips on removing the tail shaft 20T Bevel gear? The pin is in so tight i can't get it off.

Thanks

Anthony
Logged
Synergy E7 - 4525 Ultimate, 8917HV, HBL980, Vbar Silverline, HW 120HV, Quasar 7075 BEC, Edge 693/115
Synergy E7 - 4525 Ultimate, 8717HV, HBL980, Vbar Silverline, Scorpion 130A, HV2 BEC, Rail 696/116

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
How to replace tail shaft bevel gear?
« Reply #1 on: October 04, 2012, 03:18:09 PM »
There is a set screw on the pin. It's down inside the shaft. There is a open end on the gear side. Out your driver down into the shaft. Loosen the set screw and the pin will push out. It's a 1.5mm driver. Maybe 1.0


Sent from my iPhone using Tapatalk
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Jean-Luc Bolduc

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 614
Re: How to replace tail shaft bevel gear?
« Reply #2 on: October 04, 2012, 03:38:57 PM »
1.5mm driver.
Logged
Team Synergy

Offline Anthony Oxlade

  • Full Member
  • ***
  • Posts: 122
Re: How to replace tail shaft bevel gear?
« Reply #3 on: October 04, 2012, 04:03:09 PM »
Brilliant thanks guys. Took less than a minute to change the shaft. Should have read the manual more carefully!
Logged
Synergy E7 - 4525 Ultimate, 8917HV, HBL980, Vbar Silverline, HW 120HV, Quasar 7075 BEC, Edge 693/115
Synergy E7 - 4525 Ultimate, 8717HV, HBL980, Vbar Silverline, Scorpion 130A, HV2 BEC, Rail 696/116
Pages: [1]
« previous next »