November 22, 2024, 10:01:57 AM
« previous next »
Pages: [1]

Author Topic: Error in Torque Tube Conversion Manual  (Read 1085 times)

Offline Aterren

  • Newbie
  • *
  • Posts: 31
Error in Torque Tube Conversion Manual
« on: October 21, 2013, 10:57:36 PM »
On page 3 (including cover page) the bevel gear pin for the 20 tooth gear whould read P/N 320-412 (17 mm long) rather than 406-406 (11 mm long).


Edit 10/22/2013 to add photo and correct p/n
« Last Edit: October 22, 2013, 06:56:09 PM by Aterren »
Logged

flyalan

  • Guest
Re: Error in Torque Tube Conversion Manual
« Reply #1 on: October 22, 2013, 06:35:30 AM »
Not sure where 406-406 came from??
Are you referring to the pin for the 18T bevel gear part number 320-118.  If this is the case the 11mm pin (320-406) is the correct length and part number.
Measure the base of the gear.  Mine is 11.15mm so a 17mm pin would be way too long.

Cheers
Alan
Logged

flyalan

  • Guest
Re: Error in Torque Tube Conversion Manual
« Reply #2 on: October 22, 2013, 06:51:57 AM »
It does look like you may be referring to page 2 and the pin for the 20T bevel gear.  If so that part number should be 320-412 (17mm pin).
Please refer to the E7 SE manual.  It does have the correct information.
Cheers
Alan
« Last Edit: October 22, 2013, 06:54:21 AM by flyalan »
Logged

Offline Aterren

  • Newbie
  • *
  • Posts: 31
Re: Error in Torque Tube Conversion Manual
« Reply #3 on: October 22, 2013, 07:01:41 PM »
Alan, thanks for correcting my correction!   Original post revised with snip of manual and note with corect P/N.
Logged
Pages: [1]
« previous next »