E7se One Way Bearing

[Chris Wall]

I was looking for the size of the one way bearing - it looks like it is 10mm x 14mm x .  I wanted to see if Boca Bearings had just the replacement versus a whole new hub...

[Jon Mills]

PN# 200-407, looks to be used on several synergy kits.  Inside diameter of 14MM.  Hope this helps?

[Chris Wall]

PN# 200-407, looks to be used on several synergy kits.  Inside diameter of 14MM.  Hope this helps?

Yes, I saw that, but I was really just looking for the one way bearing, not whole hub (I did steal the 14mm from there though!).  Hub is $40, bearing alone has to be a little less (OWB for Trex 600 12 x 18 x 16 mm is $18.00)...  Thanks!  I guess when it goes bad, press it out and measure...

[Jon Mills]

Sorry I couldn't help more, I did about a 30 minute search online for it. I saw several dimensions for it but wanted to help you with the "correct info".  I would cross that river when you come to it. In the manual it does say it can be pressed in either way.  Also it says don't use grease(DUH), triflo works real good on those. 

[Chris Wall]

Sorry I couldn't help more, I did about a 30 minute search online for it. I saw several dimensions for it but wanted to help you with the "correct info".  I would cross that river when you come to it. In the manual it does say it can be pressed in either way.  Also it says don't use grease(DUH), triflo works real good on those.

Thanks for the help, I probably gave up after 15-20 minutes of searching!

[Rodney Kirstine]

I believe it's pn 108-111 and is a 14X20X16.  Hopefully someone else will confirm that because I'm not 100% sure.